H660EW

Overview

The H660EW optical network terminal is targeted for all subscribers requiring multiple high- speed data interfaces in a cost-effective indoor housing. Fully compliant with ITU-T G.984 standards, the H660EW supports data rates of 1.25Gbps upstream and 2.5Gbps downstream. With DASAN’s leading-edge GPON technology, users can enjoy bandwidth- intensive multimedia services such as real-time audio and gaming much easier and faster than ever before.

The H660EW provides one GPON uplink port, one Gigabit Ethernet (10/100/1000Base-TX) port, three Fast Ethernet (10/100Base-TX) ports and Wireless LAN interface that enhance the ability to deliver demanding Wi-Fi services. The H660EW supports the full Triple Play of services including voice and high speed internet access service. The H660EW supports at least 30 PCs connected simultaneously via a switch connecting the LAN port side.

The H660EW contains both built-in wire-speed L2 switch and L3 routing gateway with port forwarding, NAT and NAPT address translation, PPPoE client support for high speed Internet service.

View printable version

Specifications

Capabilities

System

  • MIPS 900MHz Dual core CPU
  • 128MB Flash Memory
  • 128MB SDRAM
  • GPON Interface Capacity:
  • Up 1.25Gbps / Down 2.5Gbps

GPON ONT

  • ITU-T G.984.x compliant
  • Forward Error Correction (FEC)
  • OMCI channel encryption with variable lengths
  • AES 128-bit encryption
  • At least 8 T-CONTs/ 32 GEM ports per device
  • Flexible mapping between GEM port and T-CONT
  • Support Single /Multiple T-CONT(s) mode
  • Flexible mapping between GEM Ports and T-CONT
  • Priority queues and scheduling on Upstream
  • Activation with automatic discovered Serial Number and SLID
  • Displays the SLID number without using ASCII code, but it displays the exact number
  • Dying Gasp

L2/L3/L4

  • IEEE 802.1D and IEEE 1Q
  • IEEE 802.3 auto negotiate
  • 4K source MAC address learning
  • Unicast MAC address is learned by VLAN or basic interface
  • 1 bridge group
  • Address learning with auto aging
  • Support 4K VLAN from 1 to 4094
  • Jumbo Frame 2K
  • L2 control protocol transparently transmitted with VLAN Stacking mode: STP, RSTP, MSTP, IGMP, OSPFv2, RIPv2, ARP, VRRPv2
  • VLAN Filter
  • L2/L3 Filter
  • BPDU Filter
  • VPN L2/L3 transmission in L2 bridge mode
  • L3 VPN transmission in L3 route mote. Service terminated on
  • Support IPv4 both software & hardware
  • IPv6 transparent forwarding
  • Static routing
  • DHCP server / client
  • DNS proxy
    • Auto/Manual
  • NAT/NAPT/Port forwarding, DMZ
  • NAT Loopback
  • MCL, DDNS (No-IP, DynDNS), UPnP Port mapping, ALG
  • Customize DDNS dynamic domain name to use for IP camera services retrieved through domain
  • Capable of performing domain name access from the
  • NTP
  • IPoE
  • PPPoE client
    • Automatically initiating the session
    • Automatically keep alive
  • VLAN based PPPoE/IPoE
  • Up to 5 VPN sessions concurrent. (transparent)
  • Internet & L2 VPN throughput: at least 200Mbps full duplex
  • L3 VPN throughput at least 90Mbps Full duplex
  • NAT concurrent session: 8K inside session
  • 8K outside session

Multicast

  • IGMP v1/v2
  • IGMP snooping
  • IGMP proxy
  • Provision of IPTV services in bridge mode (L2) and router mode (L3)

Quality of Service

  • HW-based internal IEEE 802.1p (CoS)
  • Strict Priority (SP)
  • 1Q (VLAN tag) QoS mapping, ToS/CoS

Management

  • ITU_T 984.4 compliant OMCI interface
  • 3x flow control
  • LED indications for maintenance
  • Web-based management
  • Remote configuration via HTTP/Telnet/SSH. Disable remote access by
  • ONT service provisioning
  • Compliant TR-69, TR-142, TR255
  • Ready to connect management system by
  • Configure all parameters on WebGUI remotely via centralized management system
  • Support Ping, Trace route
  • Dual firmware
  • Store and restore old firmware versions after upgrading new versions.
  • Support backup/restore configuration, firmware upgrade remotely
  • Do not lose configuration when power off and when the power supply is unstable
  • Support log file
  • Tx/Rx power display on device
  • Maximum 6 minutes’ service interruption during the upgrade process
  • Access WEBGUI configuration on a variety of Smartphones

Wireless LAN

  • 11b/g/n compliant
  • Support 4
  • Support each SSID serve for 1 separate service
  • Up to 25 devices can accessed simultaneously
  • MAC based access control
  • 64/128bit wireless encryption protocol (WEP)
  • Bandwidth: 2.4GHz
  • Two Transmit and Two Receive path (2T2R)
  • 2×2 MIMO
  • data rate: 54Mbps in 802.11g
  • data rate: 300 Mbps with 40MHz channel in 802.11n
  • Two-stream spatial multiplexing
  • Supports 20 MHz and 40 MHz channels
  • Security: WEP, WPA-PSK (TKIP) & WPA2-PSK (AES)
  • Wi-Fi enable/disable
  • Support broadcast hidden SSID
  • Split traffic on SSIDs
  • Wifi client statistic
  • Support WPS (Wi-Fi Protected Setup): PIN (Personal Identification Number) & PBC (Push Button Configuration)
  • Wifi stations accessing services via wifi are not affected by other stations with RSSI ≤ -80dBm.

Security

  • Support SPI firewall
  • Prevent: DOS/DDOS attack
  • Disable Web management on WAN by default
  • URL filtering, IP filtering
  • Do not allow storing and executing strange code automatically.
Physical Specifications

Mechanics

  • Dimensions (W x H x D)

6.30 x 2.14 x 5.12 in – (Antennas folded)

(160 x 54.30 x 130 mm)

Operating temperature 23 to 122°F (-5 to 50°C)Environmental Conditions

  • Storage temperature: -22 to 140°F (-30 to 60°C)
  • Operating humidity: 5 to 90% (non-condensing)

Power Voltage (AC/DC Adapter)

  • Switching power adapter
  • Input: 100-240VAC, 47 ~ 63 Hz
  • Output: 12VDC
  • Nominal Power: 6W
  • Power efficiency ≥ 80%
  • Limited input current: 2A
  • Maximum inrush current: 30A
  • ONT nominal load current: 150mA
  • Protect from overvoltage input: ≥ 2KA@8µs/20µs.
  • Output voltage limit ≤ 5% of nominal voltage
  • Ripple voltage and output noise: ≤ ± 1% Nominal Voltage
  • Over voltage when power off: ≤ 110% Nominal Voltage
  • Nominal output current greater than 3.3 times the average load current
  • Overcurrent resistant: ≥ 150% of nominal load current, output voltage in overcurrent protection mode ≤ 20% of nominal output voltage
  • Overcurrent protection, output short circuit: Adapter will stop working when operating in overcurrent protection, short circuit and resume operation when the output is no longer overcurrent or short circuit.
  • Insulation between input (AC) and output (DC): ≥ 1.5kV, leakage current <5mA
  • Insulation resistance between input (AC) and output (DC): ≥ 10 MΩ
  • AC power plug: 2-pin round type
  • DC power connector 5.5mm x 1mm
  • DC power cable: Flexible double copper wire length ≥ 1.5 m, cross- section copper conductor suitable for rated power (≤ 6A / mm2)
  • IEC 60950 safety
  • Not affect the device when the power is turned on and off
  • Operating temperature: 0 to 40°C
  • Operating humidity: 20-85% RH

Interface Parameter

  • GPON i/f

1 GPON port (SC/APC type)

  • Ethernet i/f

1 10/100/1000Base-TX ports (RJ45)

When operating with UTP Cat-5e/6 copper cable the distance reaches 100 meters. 3 10/100Base-TX ports (RJ45)

When operating with UTP Cat-5 copper cable the distance reaches 100 meters.

  • Wireless LAN

IEEE802.11b/g/n compliant Dual MIMO antenna, 5dBi gain

TX power ≥ -18 dBm (Measured at the antenna front)